IQ PROCESS CONTROL
INTEGRITY / QUALITY
On the Cutting Edge of Gas Well Dewatering Technologies

Toll Free: 800.514.1110

Home » IQ Smart Drive Plus

IQ Smart Drive Plus

Our Smart Drive Plus offers all the same features as our Smart Drive, with some added elements to enhance its value. It also learns (with the smart-time feature) the flow recovery rates of the well and begins self-adjusting until it understands the well’s inflow patterns. And, as with the Smart Drive, it requires minimal maintenance as it has been field tested for ten years with very little downtime. See the ‘Built-in Features’ below to review everything set into this drive or view our demo of the IQ Smart Drive Plus. Link to demo.

IQ Smart Drive Plus Requirements IQ Smart Drive Plus Built-In Features
Designed for 480V 3 phase motor, + or – 5% voltage Smart Logic cycling with minimum run time adjustment
Can be used for 480V single phase supply 5-10 HP motor Motor overload protection
Can be used for 480V three phase supply 10-20 HP motor Over and under voltage protection
Must have one 4-20 ma, 0-300 psi, class 1 div. 2 pressure transducer. Phase loss and reversal protection
When used for high and low casing pressure, a 0-10v class 1 div. 2 transducer is required. Phase conversion from single to 3 phase
Inherent pump-off control
Remote communication capability
Precise high and low discharge pressure protection
Casing pressure protection
Display monitors for run percentage and cycles per day
Extended Logic
User-friendly operator interface
Stability control (Auto -speed throttling upon gas interference)
Calculated BPD water
Max head protection (Pump will shut down if over-pressured)
Trending of operating parameters, for historical trouble shooting
Heat tape circuit GFCI (For future heat tape to prevent well freezing)
TVSS (50 Ka Transient Voltage Surge Suppression)
Unit cooling (Thermostatically controlled)
Internal memory for additional features, if needed
Downloading trending information to a laptop computer
Real time monitors on HMI screen
Daily and average operating information on one screen on HMI
On-screen trouble shooting guide
Mounted in a WP enclosure
A long lead filter is included

Comments are closed.

Smart Drive


Smart Drive

Once our stand-alone drive is set up in the field and tailored to the individual well characteristics, it will begin to learn the flow recovery rates of the well and begin self-adjusting until it understands the well's inflow patterns.

Smart Drive Plus


Smart Drive

Our Smart Drive Plus offers all the same features as our Smart Drive, with some added elements to enhance its value. It also learns the flow recovery rates of the well and begins self-adjusting until it understands the well's inflow patterns.